Many Mithril Pages @ Faerylands

Hi bucca, welcome to this wonderful forum. Well, I can say something helpfully to your question. I have to collect lots of the minis via ebay. Therefor there are a LOT of minis, which are in a very ugly condition. That means, especially, ugly painted with strange colours. I had to remove this ugly paint often, and, of corse the original mithril undercoat removed as well.
The miniature was "blank". I had to undercoat the minis again for myself. I took enamel paint and use the colour really thin.
But, unfortunately it was something like smearing up the fine details. The best results for that I have received in thinning the enamel colour.
For that I use "orange terpene".  (Everybody in the room suddenly long for an Orange Margarita . . . )
That was the only result which was acceptable to me. ( You will value the mithril undercoat . . )
May I tell you: please do NOT take car primer for those little treasures . . .
I hope this would be a little help for you. Always welcome.

Hmmm

Well, my experience is thusly.

Spraying primer into the grey Mithril primer tends to lose details. The amount of detail lost depends on how the spray can is faring. Generally if the mithril undercoat is doing its job, I don't spray. I just paint the mail shirts and things black, then go from there.

For some miniatures, especially if the grey primer is getting ratty - as some ebay bought figures will - its probably worth stripping the primer off with "Simple Green" and repriming it with either Vallejo Grey Undercoat, or Games Workshop black undercoat.

Gavin

Welcome to mmp bucca.

If the Mithril coating is in good shape, I'd go with Gavin's advice and put a thin layer or two of black paint on and go from there.  If not, I'd remove it all and prime with whatever you usually use.

There isn't a Mithril painting guide, just a collection of tips and tricks for painting in general.  Feel free add some if you'd like. 

Please do post a pic when you finish! 

Thank you all for your kind advice and encouragement.

My first will already have nice 'blister-fresh' undercoat so thinned black over that it shall be and where that takes me who knows....having said that, I'm now stuck as to which to paint first....mmmm...rarest, smallest, largest, mannish, orcish, something-else-ish....

Anyway, I will definitely post a pic when in progress and then when completed, but being (one of the) slowest painters in the world that may be anytime

Bucca

and you are not the only one . . .

Hi bucca, I just primed the parts of the new MF-releases where I had to cut. So I can tell that "Humbrol Nr1 matt" matches the present Mithril coating exactly.
As for coating I'd like to suggest never to use a spray. Use some brushes and take your time to make sure you have covered each and every detail of the figure. This way you will become aware of details. When you see parts of your coating still being 'shining' after about 5 minutes, you should drybush those parts immediately.
In case you want to assemble larger pieces, as Dragons or some vignettes, that 'enamel' colour helps you to close some last gaps between some parts.
Just trying to give my help ... knowing I'm not that perfect

Wendy wrote:
So I have some competition in slowness, then.

Ah yes, but if my results are anything like your Knights of Dol-Amroth, then patience is certainly a virtue

And to Theobald, thank you for the advice....one thing is certain I will indeed take my time

I never saw Bucca close the loop on how the thin coats of black primer worked for him.

I'm in the same boat as Bucca - I prefer to have a black undercoat.  Are there other painters out there on this site who prefer black undercoat.  What do you do?

Gone...that was a quick visit !